Magnum Venus Plastech System One FRP 3101-00-01 - Manual (Page 6)

FRP SystemOne 3
Fluid Section Disassembly Procedures:
1. Remove the two 7201-6-8 (Hex Nuts) from the 3101-20-1 (Pump
Cylinder Tie Rods).
2. Slide the 3101-21-1 (Foot Valve Collar), 3101-19-1 (Foot Valve) and
3101-16-1 (Cylinder) down off the 3101-9-1 (Piston Rod), discard
the Two 7301-1-137 (O-Rings). Remove the 3101-17-1 (Ball Stop)
and 3101-18-1 (Foot Valve Spring). Remove and discard the
9201-2-36 (1 1/4” Chrome Ball). Clean and inspect ball seat area of
3101-19-1 (Foot Valve).
3. Loosen 3101-1-1 (Packing Nut) and slide the 3101-9-1(Piston Rod)
out the bottom of the 3101-7-1 (Outlet Body).
4. Unscrew the 3101-15-1 (Piston Nut) from the 3101-11-1 (Piston
Body). Remove the two 3101-12-1 (Piston Cups), 3101-14-1
(Piston Cup Back-up) and 3101-13-1 (Piston Cup Spacer) from the
3101-11-1 (Piston Body). Discard the two 3101-12-1 (Piston Cups).
5. Unscrew the 3101-11-1 (Piston Body) from the 3101-9-1 (Piston
Rod). Remove the 9201-2-28 (7/8” Chrome Ball) and the 3101-10-1
(Piston Ball Spring) Discard the 9201-2-28 (Chrome Ball – 7/8”)
6. Remove the 3101-1-1 (Packing Nut) from the 3101-7-1 (Outlet
Body). Use a 1/4” wooden dowel to push the 3101-4-01 (Packing
Set Assembly) out the top of the 3101-7-1 (Outlet Body). Discard
the packing set
. Clean and inspect the 3101-2-1 (Guide Bearing),
3101-3-1 (Female Compression Ring), 3101-5-1 (Male
Compression Ring), 9203-1-1 (Wave Spring), and 3101-6-1 (Spring
Support Ring).
7. Clean and inspect all parts that will be reused, replace as needed.