Magnum Venus Plastech System One FRP 3102-00-01 - Manual (Page 6)

FRP SystemOne
Gelcoat 3
Fluid Section Disassembly Procedures:
1. Remove the two 7101-3-52 (Hex Head Bolts) from the 3102-6-1
(Outlet Body).
2. Slide the 3102-18-1 (Foot Valve Collar), 3102-17-1 (Foot Valve
Body) and 3102-14-1 (Cylinder) down off the 3102-7-01 (Piston
Rod), discard the two 7301-3-129 (O-Rings).
3. Remove the 3102-15-1 (Ball Stop), 3102-20-1 (4 Lobed Ball Guide)
and 9201-2-24 (3/4” Chrome Ball). Discard the Chrome Ball.
4. Clean and inspect the ball seat area of the 3102-17-1 (Foot Valve
Body).
5. Loosen 3102-1-1 (Packing Nut) and slide the 3102-7-01 (Piston
Rod) out through the bottom of the 3102-6-1 (Outlet Body).
6. Unscrew the 3102-13-1 (Piston Body) from the 3102-7-01 (Piston
Rod). Remove the 9021-3-16 (1/2” Chrome Ball) and the 3102-8-1
(Piston Ball Spring). Discard the 1/2” Chrome Ball.
7. Slide the 3102-9-1 (Piston Cup Comp Ring), the two 3102-10-1
(Piston Cups), 3102-11-1 (Piston Cup Spacer) and the 3102-12-1
(Piston Cup Backup) from the 3102-13-1 (Piston Body). Discard the
Piston Cups.
8. Remove the 3102-1-1 (Packing Nut) from the 3102-6-1 (Outlet
Body). Use a 1/4” Wooden Dowel to push the 3102-2-1 (Guide
Bearing), 3102-3-1 (Female Comp Ring), 3102-4-01 (Packing Set
Assy), 3102-5-1(Male Comp Ring) and 9203-1-2 (Wave Spring
Assy) through the top of the 3102-6-1 (Outlet Body). Discard the
Packing Set Assy.
9. Clean and inspect all parts that will be reused, replace as needed.