Magnum Venus Plastech PATRIOT Multi-Color Gel Coater MVG-PAT-1500XINT - Manual (Page 32)

Patriot Multi-Color Operations Manual
Rev. 08/2012 Page | 32
Internal Mix Daily Start-Up:
1.
Check all hoses for damage.
2.
Check all material supplies and fill or replace as needed.
3.
Close the flush tank relief valve
4.
Open recirculation valve on Catalyst Manifold
5.
Open main inlet air valve on the manifold.
6.
Remove the Pivot Pin from the catalyst drive.
7.
Manually pump the catalyst pump with the catalyst drive, observe catalyst
returning to the catalyst jug, pump until the stream is air free.
8.
Close recirculation valve on Catalyst Manifold.
9.
Manually pump the catalyst pump with the Slave Arm drive, bring catalyst
pressure to operating pressure 100
– 200 psi.
10.
Check pump pressure, if adjustment is needed press and hold the priming button
while adjusting air pressure - slowly turn up the pump air pressure to the
operating pressure.
11.
Replace the Pivot Pin into the catalyst pump drive.
12.
Insert the Distribution Ring into the Mix Chamber locating rim.
13.
Place mix housing Seal into the Mix Chamber locating rim.
14.
Insert the Catalyst Injector and injector seal into the aperture in the Distribution
Ring. The spring goes into the gun block.
15.
Place Mix Chamber and Catalyst Injector onto the front of the Pro Gun, secure it
with the 2 screws.
16.
Apply a small amount of Red Grease to the threads of the Mix Chamber.
17.
Install mixer, seal and air assist assembly onto the mix chamber.