Magnum Venus Plastech PATRIOT Multi-Color Gel Coater MVG-PAT-1500XINT - Manual (Page 30)

Patriot Multi-Color Operations Manual
Rev. 08/2012 Page | 30
Gun Set-Up External Mix:
Note: Use a little red grease on the o-rings and threads before installing the spray
tip, catalyst tip and retainer.
1.
Install the Gel Coat Spray Tip into the front of the gun block.
2.
Install the Catalyst Tip over the Spray Tip. Use caution not to damage the o-rings
on the front of the gun block.
3.
Install the retainer to secure Catalyst Tip and Spray Tip in place.
4.
Spray test pattern; make gel coat pump pressure adjustment until a fairly uniform
pattern is achieved. There should be slight horns on either side of the spray fan.
Slowly open the air-assist needle valve located on the side of the gun handle until
a soft uniform pattern is achieved.