Magnum Venus Plastech PATRIOT SS PAT-CCP-LS-0590-SS User Manual
Page 21
MAGNUM VENUS PLASTECH
Patriot SS Chop Check Manual
21
22. Install a new O-ring (O-E-032) onto the Lower Seat (PAT-CCP- 0518-SS).
23. Install the Lower Seat (PAT-CCP-0518-SS) into the end of the Cylinder (PAT-CCP-
0519-SS) the small chamfer side (seat) should face in towards the Intake Valve.
24. Install the Priming Seal (PAT-CCP-0524) onto the Priming Piston (PAT-CCP-0523).
25. Install the Priming Piston (PAT-CCP-0523) onto the end of the Priming Rod (PAT-
CCP-0527-SS).
26. Install onto Hex Bolt (F-HB-04F-08) a Backup Washer (PAT-CCP-0528) then the
Relief Washer (PAT-CCP-0525) then the last Backup Washer (PAT-CCP-0528)
27. Thread the Hex Bolt (F-HB-04F-08) into the end of the Priming Rod (PAT-CCP-
0527-SS).
28. Thread the four Tie Rods (PAT-CCP-0520) into the Outlet Body (PAT-CCP-0501-SS).
29. Install the Inlet Bell Frame (PAT-CCP-0537) onto the end of the Tie Rods (PAT-
CCP-0520) over the Priming Piston. It is preferable to install the Bell Frame so that
the fitting ports are perpendicular to the pump outlet.
30. Thread the four Hex Nuts (F-HN-06C) onto the end of the Tie Rods to secure the
Bell Frame and pump assembly.
Priming Rod
Priming Seal
Priming Piston
Backup Washer
Relief Washer
Hex Bolt