Magnum Venus Plastech PATRIOT SS PAT-CCP-LS-0590-SS - Manual (Page 18)

MAGNUM VENUS PLASTECH Patriot SS Chop Check Manual 18
Patriot Chop Check Pump
Fluid Section Assembly:
PISTON and PISTON VALVE ASSEMBLY:
1.
Install the Ball Stop (PAT-CCP-0511) into the bottom of the Piston (PAT-CCP-0507-
SS).
2.
Install the Spring (PAT-LS-1010) into the Piston (PAT-CCP-0507-SS) narrow end
towards the ball.
3.
Insert the Ball Guide (PAT-CCP-0512-SS) into the Piston (PAT-CCP-0507-SS) over
the Spring. (see below for proper orientation)
Note: The relief (round) end of the ball guide goes against the spring into the
piston.
4.
Install a new O-ring (O-E-022) onto the Piston Valve (PAT-CCP-0509-SS).
5.
Place the Piston Ball (VLS-2427-SS) into the Piston (PAT-CCP-0507-SS) on top of
the Spring (PAT-LS-1010).
6.
Thread the Piston Valve (PAT-CCP-0509-SS) into the end of the Piston (PAT-CCP-
0507-SS) and tighten. Set aside for now.
CHAPTER
3
Piston
Ball Stop
Spring
Piston Ball
Ball Guide
O-Ring
Piston Valve
Priming Rod