Lightronics SM192 User Manual
Page 7
INSTRUCTION MANUAL
Page 7 of 9
SM - 192 DMX LIGHTING CONTROLLER
Version 20090519
www.lightronics.com
Lightronics
Inc.
509
Central
Drive
Virginia
Beach,
VA
23454
757
486
3588
OPERATING SCENES
When the SM-192 is turned on it is in the manual scene
mode with bank 1 scene 1 active.
ACTIVATE A SCENE MANUALLY
1. Turn off PROGRAM mode, AUTO, MUSIC, and
all
chases.
2. Select the desired scene bank using BANK UP or
BANK
DOWN.
3. Push the SCENES button for the scene you want to
activate.
RUN A BANK OF SCENES AUTOMATICALLY
The scene Auto-Run function will cycle through a
bank of scenes continuously. The speed and scene
fade time can be controlled by operator. The speed is
controlled by the TAPSYNC button or the SPEED
fader. The fade time is controlled by the FADE TIME
fader. Scenes can also be synchronized to music or
MIDI note triggering.
1. Select the desired scene bank using BANK UP or
BANK
DOWN.
2. Push AUTO/DEL. The AUTO TRIGGER
indicator on the display will light and scene Auto-
Run will begin cycling.
3. You can adjust the speed and fade time as needed.
If you set a speed faster than the fade time then the
scenes will advance before the fade is complete.
4. You can switch to another bank at any time using
BANK UP and BANK DOWN.
5. Push AUTO/DEL to stop Auto-Run. The AUTO
TRIGGER indicator on the display will go OFF.
RUN SCENES AUTOMATICALLY WITH MUSIC
SYNC
The SM-192 has an internal microphone which can be
used to Auto-Run scenes with music synchronization.
SCENE MUSIC AUTO-RUN
1. Push MUSIC/BANK COPY. The MUSIC
TRIGGER indicator on the display will light.
and Music Auto-Run will begin in the currently
selected scene bank.
2. You can switch to a different scene bank using
BANK UP or BANK DOWN.
3. Push MUSIC/BANK COPY to stop Music Auto-
Run.
OPERATING CHASES
Chases can be run in several ways including Manual,
Auto-Run, and Music Auto-Run.
MANUAL CHASE OPERATION
This is used to manually step through a chase. It is
done in program mode and is useful when creating or
editing chases.
1. Enter the program mode.
2. Select a chase (1 - 6) by pushing the applicable
CHASE
button.
3. Push TAP/SYNC. The display will show the chase
and step numbers and the display STEP indicator
will
light.
4. Use the BANK UP and BANK DOWN buttons to
cycle through the chase steps.
5. When finished, exit from the program mode by
holding down PROGRAM for aprox. 3 seconds.
RUN A CHASE AUTOMATICALLY
The chase Auto-Run function will continuously cycle a
chase. Multiple chases can be run together and will
run in the order selected. The speed and fade time can
be controlled by operator. Speed is controlled by the
TAP SYNC button or the SPEED fader. Fade time is
controlled by the FADE TIME fader.
1. Select a chase (1 - 6) by pushing the applicable
CHASE button. You can select more than one.
2. Push AUTO/DEL. The AUTO TRIGGER indicator
in the display will light and the chase(s) will run.
3. You can adjust the speed and fade time as needed.
4. Push AUTO/DEL to stop chase Auto-Run. The
display AUTO TRIGGER indicator will go OFF.
NOTE: If you turn off all chases before you turn off
Auto-Run then the SM-192 will revert to scene Auto-
Run in the last accessed scene bank.