AEG LAVAMAT 60300 - Manual (Page 41)

Installation and Connection Instructions
41
Water feed
A flexible pressure tubing of 1.3m length is supplied.
If a longer feed tubing is needed, a complete VDE-approved tubing set
with mounted screw connections, supplied by our customer service,
should be used exclusively.
– For washing machines without Aqua-Control, tubing sets are
available in lengths of 2.2m, 3.5m and 5m.
– For washing machines with Aqua-Control, tubing sets are available
in lengths of 2.0m, 2.9m and 3.9m.
Attention! Under no circumstances may tubing be pieced together for
the purpose of lengthening!
3 Sealing rings are either inserted in plastic nuts of the tubing screw con-
nection or contained in an accompanying packet. Do not use other
seals.
0 1. Connect the angled hose connector to the
machine.
Attention! Plastic nut at the tube coupling
may only be hand tightened.
2. Connect the straight hose connector to a water tap
with an R 3/4 (inch) thread.
Attention! Only tighten the plastic nuts on the
hose connectors by hand.
3. By opening the water tap slowly prior to the initial
operation, check whether the connection is tight.