AEG LAVAMAT 60300 - Manual (Page 39)

Installation and Connection Instructions
39
Levelling on uneven floors
Using the four adjustable threaded feet, compensation can be made for
unevenness in the floor and the height of the appliance adjusted. The
height can be adjusted over the range +10... -5 mm.
To adjust the feet use the special spanner supplied for removing the
transport braces.
0 1.Slide the special key firmly onto the hexagon head of the threaded foot
all the way to the stop.
2. Adjust the threaded feet so that the appliance is level and sits stably.
The appliance must not rock across the corners when operating under
load.
3. If necessary, check positioning with a spirit level.
Important! Never compensate for small areas of unevenness in the
floor through the use of wooden wedges, cardboard or the like. Level-
ling should only ever be performed by adjusting the feet.
Power supply
Details on the mains voltage,
type of current and the neces-
sary fuse protection are to be
found on the rating plate. The
rating plate is above and
behind the door.
For permanent electrical con-
nection within the electrical
circuit, provisions must be made which allow for electrical disconnec-
tion of the appliance from the mains with a contact opening of at least
3 mm at all poles. Suitable devices include circuit breakers, fuses
(threaded fuses must be entirely removed from the socket), ground
fault circuit interrupters and contactors. Permanent connection may
only be carried out by an authorised electrician.
; This appliance conforms to the following EC directives
– "Low-Voltage Directive" 73/23/EWG dated 19 February 1973
and Directive amendment 93/68/EWG
– "EMC Directive" 89/336/EWG dated 3 May 1989
and Directive amendment 93/68/EWG