Lectrosonics SPNDNT - Manual (Page 6)

ASPEN Digital Processor
LECTROSONICS, INC. 6
Front Panel
Headphone Monitor
Standard 1/4 inch jack and level control. Drives both
channels of stereo headphones.
USB Port
Standard USB connector for the setup and control
from a computer using Windows XP, Vista or Windows
7 operating system. The USB port is also used for
firmware updates.
Rear Panel
Programmable Input and Output Ports
Programmable inputs and outputs used to control
levels, settings, indicate the current state of a program-
mable input and control a variety of other parameters.
Serial Port
Used for control; typically with third party products
such as touch panel displays.
Ethernet Port
Used for control only. Does not pass audio.
ASPEN Bus Data/Audio Ports
These RJ-45 jacks carry the audio signals and control
data between processors stacked together.
DNT
POWER
Switch
USB Port Alert
LED
Headphone Monitor Comm
LED
Power
LED
Status LEDs
• Comm LED - indicates USB, RS-232 and network
communication
• Alert LED - blinks to indicate fault or error
• Alert LED - glows steady in firmware update mode
• Power LED - glows to indicate power ON
Dante Ports
The network audio ports. Either port can be used with
a single network connection. When a second network
is configured for redundancy, all processors connected
to the network must have consistent connections, i.e.
all Primary ports connected to one network and all
Secondary ports connected to the other network.
Power Inlet
RS232
Serial Port
Programmable Input
and Output Ports
Data/Audio
Bus Ports
Cooling Fan
Outlet
Ethernet
Port
Primary Secondary
Dante Ports
Made In the USA