Impulse 2201 - Manual (Page 4)

Installation
Sealevel Systems SeaPORT+2/232 Page 2
Installation
Operating System Installation
Choose Install Software at the beginning of the CD and install SeaCOM.
System Installation
The screen captures below are taken from a Windows 98 installation. Your
particular operating system may differ slightly from what is shown based on
your version of Windows.
The SeaPORT+2/232 can be connected to any upstream type “A” port either at
the PC host or an upstream hub. The SeaPORT+2/232 is hot pluggable,
meaning there is no need to power down your computer prior to installation.
Connect the SeaPORT+2/232 to an upstream host or hub.
The New Hardware Found wizard will now proceed to locate the appropriate
drivers. These drivers were installed during the SeaCOM software setup
procedure. Once the drivers are found a new window will pop up indicating the
installation of each of the four new ports.
If you view the system’s Device Manager, you should have new “COM” ports
in the Ports (COM & LPT) Device Class. This is shown on the following page.