Impulse 2208 - Manual (Page 6)

© Sealevel Systems, Inc. - 4 - SeaLINK+2/232.PC User Manual
Physical Installation
The SeaLINK+2/232.PC can be installed in any spare bracket location.
Do not install the Adapter in the machine until the software has been fully
installed.
The SeaLINK+2/232.PC can be connected to any header type USB connector that
supports the Intel assigned connector pinout. The SeaLINK+2/232.PC will require no
user hardware configuration. Once you have installed the software simply plug the
SeaLINK+2/232.PC into two available USB connectors on the motherboard. The
drivers that were installed during setup will automatically be used to configure the
adapter. You should see one or more “New Hardware Found”, indicating the actual
port being created. If you view your systems’ Device Manager at this point, you
should have a new “COM” port in the Ports (COM & LPT) Device Class. You can
access your new COM: port by using the assigned COM: identifier. This assignment
will vary from system to system. At this point, the hardware is recognized. To verify
operation use Sealevel Systems supplied WinSSD diagnostic utility. WinSSD can be
found in the Start, Programs group.