Controlled Products Systems Group 1834-080 - Manual (Page 66)

6.2 Accessories
Surface Trim Ring Use to recess a surface mount unit into a wall or column. P/N 1803-150.
Flush Kit Use to install flush style units into a wall or column. Kit includes rough in
back box and trim ring. P/N 1814-165 comes with stainless steel trim
ring. P/N 1814-166 comes with gold plated trim ring.
Flush Ring Use to surface mount a flush style unit. P/N 1814-152.
Stainless Steel Case Replaces the black steel surface mount case with a stainless steel case.
P/N 1810-102.
Surge Suppressers High voltage (115 V) suppresser. P/N 1878-076. Phone line
suppresser. P/N 1878-077. Low voltage (28 V) suppresser. P/N 1878-
078.
Mounting Post Heavy-duty goose-neck mounting post with mounting plate. P/N 1200-
038. Heavy-duty goose-neck mounting post with concrete base plate for
pad mounting. P/N 1200-037.
Designer Style mounting posts; offset P/N 1200-086, straight P/N 1200-
085.
Mounting Kiosk, flush units only; P/N 1200-170.
Telephone Test Set Includes clips, cord and carrying case. P/N 1800-050.
Battery 12 volt .8 amp hour gel cell provides stand by power during power
interruptions. P/N 1801-008.
Tracker Boards Tracker expansion boards (P/N 2351-010) allow the 1833, 1835 and
1837 system to operate up to sixteen individual doors or gates, provides
door ajar and forced entry alarms, and can activate local and building
alarm systems. Also allows DoorKing gate operators to report gate
operator data and activity to the entry system.
RS-232 Cable RS-232 cable with DB-9 connector on one end and wires on the other
end. Use this cable to program the entry system from a PC using RS-
232 communications instead of the modem. P/N 1818-040.
Elevator Board Elevator control boards (P/N 2348-010) provide control of up to four
elevators, with each elevator having a maximum of 64 floors.
TCP/IP Kit P/N 1830-175 – enables the 1830 series system to send and receive
data via the DKS Internet Server or a LAN.
Page 66 1835-065-R-10-11