Controlled Products Systems Group 1834-080 - Manual (Page 47)

3.5.11 Touch Tone Dialing Pause
During touch-tone dialing, the system (by default) places a 2 second pause after dialing a line access
code (9 in a PBX system for example) and after the area code. For example:
9 (2 second pause) 1310 (2 second pause) 6450023
The 2 second pause can be removed by programming 0 into the steps below. In this example, the
system would simply dial out the line access code (9), area code (1310) and phone number
(6450023) without any pauses.
913106450023
Factory setting is 1 (pause ON).
1. Press *27 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter 0 * (beep) to turn the pause OFF, or enter 1 * to turn the pause ON..
3. Press 0# TOGETHER to end this programming step (beeeeeep).
1835-065-R-10-11 Page 47