Controlled Products Systems Group 1834-080 - Manual (Page 45)

3.5.5 Programming Names (1834, 1835, 1837 Systems Only)
In this section, names will be programmed into the system. Names are referenced to a phone
number by entering the directory code that the person’s phone number has been programmed to.
1. Press *66 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter the directory code (1, 2, 3 or 4 digits depending on what was programmed in
3.5.1) then press * (beep).
3. Begin entering the residents name one character at a time as described on page 30.
When the desired character (letter, number or space) is displayed, press * to enter
that character.
4. Repeat step 3 to enter additional characters until the desired name is displayed in the
directory. NOTE 1: 15 characters maximum. NOTE 2: If you make a mistake in steps
4 or 5, press # to clear the display and start over.
5. After the last character has been entered, press * (beep) to enter the complete name.
The display will be blank.
6. Repeat steps 2, 3, 4, and 5 to enter additional names.
7. Press 0# TOGETHER to end this programming step (beeeeeep).
3.5.6 Deleting Individual Phone Numbers
This programming sequence is used to delete a single phone number under a known directory code.
Proceed to 3.5.7 to delete the resident name.
1. Press *01 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Enter the directory code (1, 2, 3 or 4 digits depending on what was programmed in
3.5.1) then press * (beep).
3. Press # # # # # # # then press * (beep).
4. Repeat steps 2 and 3 to delete additional phone numbers.
5. Press 0# TOGETHER to end this programming step (beeeeeep).
3.5.7 Delete Names (1834, 1835, 1837 Systems Only)
This programming sequence is used to delete a resident name from the directory. These steps will
not erase the resident telephone number from the system. Go to section 3.5.6 to delete the resident
telephone number.
1. Press *65 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2. Use the A and Z buttons to locate the name that is to be erased, then press * (beep).
3. Repeat step 2 to erase additional names.
4. Press 0# TOGETHER to end this programming step (beeeeeep).
1835-065-R-10-11 Page 45