Controlled Products Systems Group RAM3030 - Manual (Page 12)

10
RAM 30-30
RAMSET
www.ramsetinc.com
Three pushbuttons are located under the dip switches for operation of the gate (see Figure 11). The opening,
stop and closing buttons can be utilized to set limit switches and verify proper system operation when
installing or servicing an operator.
Opening:
Pressing this button will cause the gate to open.
Stop:
Pressing this button will cause the gate to
stop moving.
Closing:
Pressing this button will cause the gate to close.
Reset E.R.D. Board:
Push all three pushbuttons for approximately
5 seconds. All three L.E.D.’s should blink.
L.E.D.’s light up when opening,
Closing or Stopped
“Intelligate”
Control Board
PUShBUTTON CONTROLS
MASTER SLAvE INSTALLATION
Dip Switch “C”
MASTER / SLAVE INSTALLATION
Set Dip Switch (C8) "Slave Mode" to ON for
slave operator.
(RH) Right Hand operation requires Dip Switch
(C7) "Left/Right" to be ON.
Figure 12
Figure 11