Controlled Products Systems Group 9310-080 - Manual (Page 49)

5.4 Accessories
The following accessory items can be used with the model 9310 slide gate operator.
Contact Sensor Contact sensors for use as a secondary entrapment protection device.
Miller Edge, Inc. ME120, ME123, MG020, MGR20, MGS20
Photo Cell Non-contact (photo cells) sensors for use as a secondary entrapment
protection device.
P/N 8080-010 – Infrared thru-beam, 165 foot sensing distance.
P/N 8080-011 – Photo-reflective beam, 30 foot sensing distance.
Loop Detector Detectors plug directly into ports on circuit board simplifying wiring.
P/N 9405-010 - Single channel detector.
P/N 9406-010 - Two channel detector
Loop Wire 18 AWG loop wire with XLPE insulation is ideal for ground loops.
Available in 500 and 1000 foot rolls with red, blue or black insulation.
Pre-Fab Loops Prefabricated ground loops. 24-foot circumference with 50-foot lead-in.
Available in yellow, red or blue jackets. Not for use in asphalt roadways.
Loop Test Meter Meg-ohm meter checks the integrity of ground loops.
P/N 9401-045
Control Station Three button interior and exterior control stations provide manual open-
close-stop gate operation.
P/N 1200-006 – Exterior
P/N 1200-007 – Interior (mounts into single-gang electrical box)
Manual control station provides a single toggle for NORMAL,
MOMENTARY OPEN and HOLD OPEN operation.
P/N 1200-017 – Interior (mounts into single-gang electrical box)
Time Clock 7 day and 365 day time clocks can be used to automatically open gate at
pre-set time and days. Compact clock fits inside the operator.
P/N 2600-791 – 7-day clock.
P/N 2600-795 – 365-day clock.
Surge Devices High and low voltage surge suppressers help prevent circuit board failure
caused by lightning strikes and power surges.
P/N 1876-010 - High Voltage.
P/N 1878-010 - Low Voltage.
Gate Scale Use to test ft/pounds required to move gate. P/N 2600-225
Speed Bumps Prefabricated six-foot speed bump reduces traffic speed through gate
system. P/N 1610-150
Nickel Chain Nickel plated chain.
P/N 2600-443 (10 ft. #41)
P/N 2600-444 (10 ft. #40)
Stainless Chain Stainless steel chain.
P/N 2600-475 (20 ft. #41)
Remote Reset Station Provides an audible tone and visible alarm when the operator is in a hard
shutdown condition. Includes a reset button to return the operator to
normal operation.
P/N 1404-080
9310-065-J-10-11 Page 49