Controlled Products Systems Group SD-6276-SS1Q - Manual (Page 2)

ENFORCER Outdoor Piezoelectric Request to Exit Pushbutton
2
SECO-LARM U.S.A., Inc
Specifications:
Operating voltage 12~24 VDC
Current drain 100mA@12VDC
Contact rating 2A@30VDC or 0.5A@125VAC
Ring LED
Colors reversible v a switch
Standby Red
Active Green
Output time 1~30 s, Toggle
IP rating IP65
Operating temperature 32 ~158 F (0 ~70 C)
Plate material Stainless steel
Weight
Single-Gang 3.5-oz (99g)
Single-Gang
w/Manual
Override
4-oz (113g)
Slimline 2.6-oz (74g)
Slimline
w/Manual
Override
3.1-oz (88g)
Parts List:
Piezoelectric push button ........................... 1 x Mounting screws .................................. 2 x
Wires for manual override 1 ........................ 2 x Manual ................................................. 1 x
Overview:
SD-6176-SSVQ and SD-6276-SSVQ with Manual Override button shown, other models similar.
Installation:
1. Prepare wiring to provide 12~24 VDC power and connect devices to the relay outputs.
Note: The device includes one relay with two outputs. Outputs trigger simultaneously but can be
configured independently. To set the output modes, see Relay Output Modes on page 3.
2. Remove the plastic cover from the rear of the switch and carefully pierce the rubber grommet.
3. SD-6176-SSVQ and SD-6276-SSVQ: Wire the manual override button. See page 3.
4. Wire the switch according to the diagram on the right.
Connect (-) and (+) to a 12~24 VDC power source.
Connect other devices to Outputs 1 or 2.
5. Replace the plastic switch cover and screw the plate
onto the mounting surface.
1 SD-6176-SSVQ and SD-6276-SSVQ only.
Single-Gang Slimline
4 1 /
2
”
(114mm)
LED ring
Manual
override
button
2
Piezo-
electric
pushbutton
1 5 /
8
” (42mm) 2 3 /
4
” (70mm) 1 5 /
8
” (42mm)
Side View Rear View
(Plastic switch
cover removed)
Relay adjust
Output mode
selection
Terminal blocks
Manual override
button 2
Buzzer adjust
LED color
selection
Timer adjustment
Terminal Block