Programming continued – Controlled Products Systems Group 8057-081 User Manual
Page 3

Programming Continued
8057-065-G-8-11
Copyright 2011 DoorKing, Inc. All rights reserved.
120 Glasgow Avenue
Inglewood, California 90301
U.S.A.
This device complies with the FCC Rules Part 15. Operation is subject to the following two conditions:
1.) This device may not cause harmful interference.
2.) This device must accept and interference received, including interference that may cause undesired operation.
This class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
Cet appareil numérique de la classe B respecte toutes les exigences du Réglement sur le matériel brouilleur du Canada.
Program Transmitter Codes One at a Time:
The five-digit unique code is located on the back of the transmitter (Tr).
1. Press and the four-digit Master Code.
2. Enter the five-digit transmitter code, then press
3. Repeat step 2 to enter additional transmitter codes.
4. Press TOGETHER to end programming.
1
0
“BEEP”
“BEEP”
“BEEEEEEEEEP”
0
Delete Transmitter Codes One at a Time:
The five-digit unique code is located on the back of the transmitter.
1. Press and the four-digit Master Code.
2. Enter the five-digit transmitter code to be deleted, then press
3. Repeat step 2 to delete additional transmitter codes.
4. Press TOGETHER to end programming.
1
2
“BEEP”
“BEEP”
“BEEEEEEEEEP”
0
Delete ALL Transmitter Codes at Once:
WARNING: Deleted codes CANNOT be retrieved.
1. Press and the four-digit Master Code.
2. Enter 9999, then press
3. After approximately 25 seconds, a long will be heard to end programming.
1
3
“BEEP”
“BEEP”
“BEEEEEEEEEP”
Program a Group of Transmitter Codes :
The five-digit unique codes are located on back of the transmitters (In numeric sequence).
1. Press and the four-digit Master Code.
2. Enter the five-digit transmitter code for the LOWEST number transmitter in the group, then press
3. Enter the five-digit transmitter code for the HIGHEST number transmitter in the group, then press
4. Press TOGETHER to end programming.
1
1
“BEEP”
“BEEP”
“BEEP”
“BEEEEEEEEEP”
0