American Dryer Corp. AD-758DV - Manual (Page 38)

34 JLA Limited 113372-7
c. Coin Models
1) When turning on power, or when no cycle is in progress, the display will read “Amount Required to
Start the Dryer.”
2) Insert coin(s).
3) Once the correct amount of coin(s) has been inserted, the display will prompt you to “Select
Temperature.”
4) Select temperature by pressing the “HI,” “PP,” or “LO” temperature selection buttons. The dryer
will start and will read the temperature selected and the time remaining.
IMPORTANT: To “STOP” dryer, open main door or press the red “PAUSE” button. The dryer will
stop and if the main door is not opened, the dryer will restart after approximately
30-seconds. If the main door is opened, a temperature selection button must be
pressed to restart the dryer.
5) Upon completion of drying and cooling cycles, the display will read “Anti-Wrinkle” or “donE.”
L. SHUTDOWN INSTRUCTIONS
If the dryer is to be shutdown (taken out of service) for a period of time, the following must be performed:
1. Discontinue power to the dryer either at the external disconnect switch or the circuit breaker.
2. Discontinue the heat supply:
a. GAS MODELS...discontinue the gas supply.
1) SHUT OFF external gas supply shutoff valve.
b. STEAM MODELS...discontinue the steam supply.
1) SHUT OFF external (location furnished) shutoff valve.