Power supply cable – CognitiveTPG A798 User Manual
Page 17
Chapter 3: Setting up the Printer
17
11/2012
A798-UG00001 Rev. D
A798 Thermal Receipt Printer: User Guide
Power supply cable
To avoid damaging the printer, connect the power supply last.
1
Plug the power cable into the power connector located in the center of the illustration.
2
Close the connector cover until it snaps, making sure that all the cables are aligned with the slots in the connector cover.
Double-check that the strain relief on the connector cover is aligned with the power supply cable (see “Cable routing”
section which follows).
3
Plug the power cord into the power supply.
4
Plug the power supply into a grounded outlet. When it is properly powered, the green LED on the top of the printer will
light up.
WARNING! Using this device without a grounded outlet is a safety hazard and voids the printer Warranty, Safety, FCC
and CE Mark designation.
Power
Supply
Connector
Connector Interface Panel