English, 2 advanced bios features, Amd k8 cool&quiet control – AMD GA-M61PM-S2 User Manual

Page 34: Hard disk boot priority, First / second / third boot device, Boot up floppy seek

GA-M61PM-S2 Motherboard

- 34 -

English

2-2

Advanced BIOS Features

AMD K8 Cool&Quiet control

Auto

AMD Cool'n'Quiet driver manages clock and VID to best serve the thermal,
performance and power requirements. (Default value)

Disabled

Disable this function.

Hard Disk Boot Priority

Select boot sequence for onboard(or add-on cards) SCSI, RAID, etc.
Use < > or < > to select a device, then press<+> to move it up, or <-> to move it down the list.
Press to exit this menu.

First / Second / Third Boot Device

Floppy

Select your boot device priority by Floppy.

LS120

Select your boot device priority by LS120.

Hard Disk

Select your boot device priority by Hard Disk.

CDROM

Select your boot device priority by CDROM.

ZIP

Select your boot device priority by ZIP.

USB-FDD

Select your boot device priority by USB-FDD.

USB-ZIP

Select your boot device priority by USB-ZIP.

USB-CDROM Select your boot device priority by USB-CDROM.

USB-HDD

Select your boot device priority by USB-HDD.

Legacy LAN Select your boot device priority by Legacy LAN.
Disabled

Disable this function.

Boot Up Floppy Seek

During POST, BIOS will determine the floppy disk drive installed is 40 or 80 tracks. The 360K type
is 40 tracks and the 720K, 1.2M and 1.44M types are all 80 tracks.

Enabled

BIOS searches for floppy disk drive to determine it is 40 or 80 tracks. Note that
BIOS can not tell from 720K, 1.2M or 1.44M drive type as they are all 80 tracks.

Disabled

BIOS will not search for the type of floppy disk drive by track number. Note that
there will not be any warning message if the drive installed is 360K. (Default
value)

Advanced BIOS Features

AMD K8 Cool&Quiet control

[Auto]

` Hard Disk Boot Priority

[Press Enter]

First Boot Device

[Floppy]

Second Boot Device

[Hard Disk]

Third Boot Device

[CDROM]

Boot Up Floppy Seek

[Disabled]

Password Check

[Setup]

Init Display First

[PCI Slot]

KLJI: Move

Enter: Select

+/-/PU/PD: Value

F10: Save

ESC: Exit

F1: General Help

F5: Previous Values

F6: Fail-Safe Defaults

F7: Optimized Defaults

Item Help

Menu Level`