beautypg.com

Codelocks CL5020 Mortice Latch with Double Cylinder User Manual

Page 7

background image

See page 8 for CL5010BB and page 10 for CL5020 Installation Instructions

12

Apply the front plate over the spindle, passing the cable tube
through the door and the latch support post through the
latch. Place the fixing plate over the cable tube and spindle.
If installing the Audit Trail Option take the USB Connector
(19) and place over the cable tube, securing in place with
double sided tape. Screw the ring nut onto the cable tube
until finger tight. Fit the alignment insert over the spindle.
Screw the fixing bolts through to the front plate.
(See diagram D).

13

Check that the spindle turns freely, and the latch retracts and
projects smoothly, with the alignment insert in place. If it is
tight, loosen the fixing bolts slightly and adjust the position
of the fixing plate until the spindle will turn freely. Tighten
the fixing bolts. Test the spindle again. Do not over-tighten
the bolts as this may cause the door to distort and affect the
lock function.
REMOVE THE ALIGNMENT INSERT.

7

Screw the cable tube into the front plate, passing the cable through the
tube. For doors less than 45mm (1

25

/

32

”) thick screw the tube all the

way to the end of the thread. For doors more than 45mm (1

25

/

32

”) leave

an appropriate amount of thread showing to accommodate ring nut

.

Example: For a 60mm (2

3

/

8

”) thick door leave 15mm

(

3

/

5

”) of thread

showing.

8

Fit the self-adhesive gaskets to the front and back plates. The gaskets
provide friction against the door so that it is not necessary to over-
tighten the fixing bolts to provide stability.

9

Remove the 4 socket head bolts from the back plate (2 are found
under the battery cover). This will release the inside fixing plate.

10

Cut the fixing bolts to correct length. Measured from beneath the bolt
head, the length should be the door thickness, plus approximately
15mm

(

3

/

5

”) to the nearest cutting point of the bolt.

N.B.

Always cut the bolts at one of the cutting points so as not to

damage a thread. Use the cutting edges of pliers to crimp strongly
several times around the selected cutting point. The surplus end
should break off quite easily.

11

Put the spindle into the latch with the spring on the front plate side of
the door.

7

Continued overleaf

CL5010 only

Alignment insert
MUST be removed
before completing
installation.

Optional USB Stick (20).

Optional USB Connector (19).

CL 5000AT installation instructions 09-13_Layout 1 13/09/2013 11:22 Page 7