Codelocks CL5020 Mortice Latch with Double Cylinder - Manual (Page 4)

You should familiarise yourself with the operation of the lock and
check that all parts work properly.
Remove the battery cover from the back plate and install the 4 x AA
cells supplied.
Connect the cables from the front plate and back plate. A BEEP
should be heard when you do this. If no BEEP is heard then check
that the batteries are correctly installed.
Place the long spindle in the front plate socket and using finger grip
only, test that the spindle is easily moved 80
o in both directions.
Leave socket in the centred position.
Enter the factory Master Code #1234.
The Blue LED should flash and the spindle should not turn as
before. After 5 seconds the Red LED should flash and the spindle
should turn easily again. This confirms that the clutch engaged
correctly when the code was entered.
N.B.
When the Master Code is entered 3 times consecutively
without performing a programming function, a penalty time of 10
seconds is activated.
Disconnect the cables.
For the CL5020 locks see page 10 to check the operation of the
mortice lock.
REMOTE RELEASE OPTION
Cables are provided for the REM 1 and REM 2 terminals on the
circuit board (Fig 1).
OPERATIONS CHECK SPECIAL FIXING NOTE
4
AUDIT TRAIL OPTION
If the CL5010AT is ordered, it will be supplied with parts 18,19, 20
and 21 from the contents list.
The Data Transfer Cable (18) will be fixed to the PCB in position 5,
see Fig 1 below.
Note : To upgrade a standard CL5010 lock to one with Audit Trail
functionality, an upgrade kit (P5000 AT KIT) can be purchased,
which includes parts 18,19, 20 and 21.
FIG 1
1. Battery
2. Remote 1
3. Remote 2
4. Clutch/Actuator
5. Data Cable Connector
(AT option only)
CL 5000AT installation instructions 09-13_Layout 1 13/09/2013 11:22 Page 4