Using web viewer – CNB NXE3055MR User Manual
Page 20
20 / 23
Network Weatherproof Camera Installation Manual
4. Using Web Viewer
You can connect to the camera using your internet browser or a software called “CMS”. This section covers
the connection through your web browser only. For instructions on how to configure the network connection
using the
CMS software,
please refer to the manual for the
CMS, which can be found in the installation CD.
4
4
.
.
1
1
.
.
L
L
o
o
g
g
g
g
i
i
n
n
g
g
I
I
n
n
Enter the IP address of the camera on the address bar of your web browser.
Then the following webpage will appear:
Figure 4-1. Log-in Box
Enter the user name and password to go to the web viewer page. The default id and password is “root”
and “admin”. If you have changed the HTTP port number from the default value, put a colon and the
port number at the end of the IP address. (For example, enter the following address when you changed
the port to 8080: http://192.168.123.100:8080)
(When using the default IP address and port number)
http://192.168.123.100
(When the IP address and port number have been changed)
address: new port number
If you forget the administrator’s password, “Factory Reset” is the only way to regain access.
However, since this will retrieve all default settings, the network settings have to be configured
again using the IP installer.
For security, please change the administrator’s id and password from their default values. Please
save the changed ID and password in a place only accessible by an administrator. Please refer to
[User Manual] for detail
.