CNB MXC6050IR User Manual
Page 16
M
M
X
X
C
C
6
6
0
0
5
5
0
0
I
I
R
R
U
U
s
s
e
e
r
r
’
’
s
s
G
G
u
u
i
i
d
d
e
e
Rev.1.0 (Dec. 2013)
16
4.2. Quick Installation Guide
4.2.1. Connect PC and MXC6050IR to network.
1. Prepare a PC to run programs for the installation and video connection
(PC is needed to assign IP address to MXC6050IR)
2.
Connect
MXC6050IR
as shown in dotted line in Figure 4-1. The DC power through DC adaptor is no need
to connect if LAN switch supports PoE (IEEE802.3af).
Figure 4-1. Power and network connection
4.2.2. Install IP Installer and Set IP Parameters on MXC6050IR.
Run the CD and Install IP Installer included in CD. Once install IP Installer, “WinPcap” will be installed. If not
install “WinPCap”, IP Installer won’t operate.
IP installer Ver. 3.0.1 or later is needed in the configuration of MXC6050IR.
Follow the sequence below for setting the IP parameter
1.
Run IP installer > Select Network Adaptor >OK
2.
Click
① in IP installer window.> Double click on
② > Fill in ④ > make a selection in ⑤ > Fill the
parameters in ⑥
3.
Click on ⑨ to apply the settings.
4.
You can connect to admin page by clicking on ⑩.
LAN switch with
standard POE
(802.3af)
LAN switch
DC adaptor