KT&C KPC-N751NU - Manual (Page 20)

9. OSD MANUAL
- BLC ZONE : Enable user to set the BLC area
-> TOP, BOTTOM, CENTER, LEFT, RIGHT.
- BLC LEVEL : Enable user to set BLC in selected
area(0~15 level).
- INITIAL : Enable user to initialize the BLC setting.
5. DAY&NIGHT
: Conversion of output image COLOR / BW depending on exterior environment
Enable user to set the LEFT, RIGHT KEY in menu.
- D&N MODE
① COLOR : Enable user to fit the output image in color.
② B/W : Enable user to fit the output image in B/W.
③ AUTO :
Enable user to convert to COLOR/BW automatically.
- DWELL TIME : In D&N MODE AUTO, enable user to
set to delay time for changing COLOR/BW(0~10sec).
- D->N LEVEL
: Day(Color) to Night(BW) a Sensor level(0~19).
- N->D LEVEL
: Night(BW) to Day(Color) a Sensor level(1~20).
- BURST
: In BW mode, Color burst signal ON / OFF.
- IR OPTIMIZER
: By the IR LED light, the screen is saturated, and automatically adjust the brightness,
so you can see the screen.
- IR OPT. LEVEL
: Enable user to control the Level (0~15steps).
- LED CONTROL
① MANUAL : IR LED brightness is adjusted manually.
② AUTO : IR LED brightness is adjusted automatically.
- LED LEVEL
: Enable user to control the IR-LED Level (0~15steps).
- INITIAL
: Enable user to initialize the setting in DAY&NIGHT menu.
20
DAT&NIGHT
>DAY&MODE AUTO
DWELL TIME 3SEC
D -> N LEVEL 1
N -> D LEVEL 3
BURST OFF
IR OPTIMIZER ON
IR OPT.LEVEL 8
LED CONTROL MANUAL
LED LEVEL 15
INTIAL
RETURN
TOP
BOTTOM
LEFT CENTER RIGHT