IQinVision Sentinel Series - Manual (Page 15)

15
14 Camera / Lens Adjustment / Remote Back Focus
1. Using the supplied 3mm Allen wrench, loosen any two adjacent screws of
the four available ball pivot screws (Figure 17). This should loosen the ball
enough to allow repositioning of the camera to the desired orientation.
Tighten the screws to secure the camera module in place.
2. For the ceiling or parapet mount, it may be necessary to rotate the lower
portion of the ball bracket. This can be achieved by loosening the two
3 mm Allen screws on the bottom of the arm elbow (Figure 18).
NOTE: DO NOT REMOVE the screws in the elbow of the mount as they can be very difficult to re-insert.
Once the lower arm is rotated to the necessary position, retighten the elbow
3 mm screws.
3. Remove the lens cap with the supplied Allen wrench to expose the lens
(Figure 19).
Figure 17
Figure 18
Figure 19