INTELLINET NETWORK 524735 Wireless 300N PoE Access Point User Manual - Manual (Page 60)

54
2-7-5 802.1x Authentication
You can enable 802.1x user identification (based on the RADIUS
user authentication server) by checking the “Enable 802.1x
Authentication” box when you select “Disable” or “WEP” as the
encryption type. The following message will be displayed:
Here are descriptions of every setup item:
Select SSID
Choose the SSID you wish to configure.
Use internal
MD5/PEAP
RADIUS Server Uses the built-in RADIUS server (refer to next
section) instead of an external RADIUS server.
If you check this box, the value of the internal
RADIUS server fields will be ignored.
Enable 802.1x
Authentication Enable or disable the use of 802.1x user
authentication.
RADIUS Server
IP address Input the IP address of the RADIUS
authentication server here.
RADIUS Server
Port Input the port number of the RADIUS
authentication server here. Default is 1812.
RADIUS Server
Password Input the password of the RADIUS
authentication server here.
After you finish with the settings, click “Apply” and the following
message will be displayed: