INTELLINET NETWORK 560771 16-Port Fast Ethernet Rackmount PoE+ Switch (8+8) - Manual (Page 2)

2
ENGLISH
16-Port Fast Ethernet PoE+ Switch English
Thank you for purchasing the Intellinet Network Solutions ™ 16-Port Fast Ethernet PoE+
Switch, Model 560771. For specifications, go to intellinet-network.com.
CONNECTIONS & INDICATORS
LEDs
The LED indicators — Power,
PoE, Link/Activity — make it
easier to monitor the switch
and its connections. NOTE:
Only Ports 9-16 can provide
power to a connected device;
all powered devices should
also comply with IEEE 802.3af.
Ports
All ports on the switch support Auto-MDI/MDI-X functionality, so crossover cables and
uplink ports are not needed for connections to PCs, routers, hubs, other switches, etc.
Cat5/5e/6 UTP/STP cables provide optimal performance; if a status LED doesn’t indicate
a link or activity, check the corresponding device for proper setup and operation.
Power
Use the included power cord to connect the device (next to the On/Off switch on the
rear panel) to an AC outlet. Confirm that the power LED on the front panel is lit.
INSTALLATION
Prior to use, it is recommended that the switch be placed/positioned:
• on a level surface with at least 25 mm (approx. 1”) of clearance for ventilation;
• away from sources of electrical noise: radios, transmitters, broadband amplifiers, etc.;
• within 100 m (approx. 328’) of network devices it’s to be connected to.
Rackmount
The switch includes brackets and screws for optional rack mounting.
1. Disconnect any cables from the switch.
2. Position a bracket over the mounting holes on one side of the switch and secure it
in place with screws.
3. Repeat Step 2 on the other side of the switch.
4. Position the switch in the rack and screw the brackets to the rack.
5. Reconnect any cables.
Power
1 3 5 7 9 11 13 15
2 4 6 8 10 12 14 16
PoE
PoE
Link/Act
Link/Act
1 3 5 7
2 4 6 8
LED Status Operation
Power
On Power on
Off Check the AC connection; turn the power on
PoE On Port is linked to a PSE/PoE device
Off No PSE/PoE device is linked
Link/Act On Valid port connection
Blinking Valid port connection; data transmitted/received
Off No link established
16 RJ45 10/100M ports (1-8 shown)