INTELLINET NETWORK 524148 24-Port Gigabit Ethernet Rackmount Switch Quick Install Guide - Manual (Page 2)

2
ENGLISH
Gigabit Ethernet Rackmount Switch English
Thank you for purchasing the Intellinet Network Solutions ™ Gigabit Ethernet
Rackmount Switch, Model 524148 (16-port) or 524162 (24-port). For specifications,
go to intellinet-network.com.
CONNECTIONS
• All ports on the switch support Auto-MDI/MDI-X functionality, so you can use straight
or crossover UTP/STP cables to connect the RJ45 ports to PCs, routers, hubs, other
switches, etc.
• The LED indicators — Power, Link/Activity — make monitoring and troubleshooting
easier. If a status LED doesn’t indicate a link or activity, check the corresponding
device for proper setup and operation.
• Use the included power cable to connect the receptacle on the back of the switch to
a power outlet, and confirm that the Power LED lights.
PLACEMENT
Prior to use, it is recommended that the switch be placed/positioned:
• on a level surface that can support the weight of the switch (and any other items
that need to be considered);
• with a minimum of 25 mm (approx. 1”) of clearance on the top and sides for
adequate ventilation;
• away from sources of electrical noise: radios, transmitters, broadband amplifiers, etc.;
• where it cannot be affected by excessive moisture; and
• within 100 m (approx. 328’) of network devices it’s to be connected to.
Rackmount
The switch includes brackets and screws for optional rack mounting.
1. Disconnect any cables from the switch.
2. Position a bracket over the mounting holes on one side of the switch and secure it
in place with screws.
3. Repeat Step 2 on the other side of the switch.
4. Position the switch in the rack and screw the brackets to the rack.
5. Reconnect any cables.
LED Status Operation
PWR On
Power on
Off Check connection; turn power on
LNK/ On Valid port connection
ACT Blinking Data transmitted/received
Off No link established