INTELLINET NETWORK 560542 8 Ports Gigabit PoE+Web Management Desktop Ethernet Switch Quick Install Guide - Manual (Page 2)

2
ENGLISH
PoE Web-Managed Desktop Gigabit Switch English
LED Status Operation
Power
On Power on
Off Check the AC connection; turn the power on
PoE On Port is linked to a PSE/PoE device
Off No PSE/PoE device is linked
Link/Act On Valid port connection
Blinking Valid port connection; data transmitted/received
Off No link established
For specifications and detailed instructions, refer to the user manual on the
enclosed CD or at intellinet-network.com..
CONNECTIONS & INDICATORS
LEDs
The LED indicators — Power,
PoE, Link/Activity — make it
easier to monitor the switch
and its connections.
Ports
All ports on the switch
support Auto-MDI/MDI-X
functionality, so crossover cables and uplink ports are not needed for connections
to PCs, routers, hubs, other switches, etc. Cat5/5e/6 UTP/STP cables provide
optimal performance; if a status LED doesn’t indicate a link or activity, check the
corresponding device for proper setup and operation. NOTE: The recessed Reset
button can be pressed (using a pin or similar pointed object) to reset the switch if
it isn’t responding.
Power
Use the included power cord to connect the device (next to
the On/Off switch on the rear panel) to an AC outlet. Confirm
that the power LED on the front panel is lit.
INSTALLATION TIPS
Prior to use, it is recommended that the switch be placed/positioned:
• on a level surface with at least 25 mm (approx. 1”) of clearance for ventilation;
• away from sources of electrical noise: radios, transmitters, broadband amplifiers,
etc.
ON
OFF