INTELLINET NETWORK 524995 Wireless 300N Dual-Band USB Adapter User Manual User Manual

Page 22

mutually authenticate with a new AP by performing a complete LEAP

authentication, including communication with the main RADIUS server.
When a wireless LAN is configured for fast re-association, however,

LEAP-enabled client devices roam from one access point to another

without involving the main server. Using Cisco Centralized Key

Management (CCKM), an access point configured to provide wireless

domain services (WDS) takes the place of the RADIUS server and

authenticates the client so quickly that there is no perceptible delay

in voice or other time-sensitive applications.

Enable Radio Measurement: When this parameter is enabled, the Cisco

AP can run the radio monitoring through the associated CCX-compliant

clients to continuously monitor the WLAN radio environment and

discover any new APs that are transmitting beacons.

Non-Serving Channel Measurements: The Cisco access point can

perform monitoring measurements through the CCX-compliant clients

on the non-serving channels when this parameter is enabled.

Limit [xxx] milliseconds (0-2000): This setting limits the channel

measurement time. The default value is 250 milliseconds.

Turn off RF: Click to turn off the radio; click again to turn it back on.

WMM

This screen enables you to configure WMM (Wi-Fi Multimedia) and

other QoS settings, such as Power Save and Direct Link Setup.

CONFIGURATION