INSTEON Thermostat Adapter (2441V) Quick Start - Manual (Page 2)

Page 2 of 2
Rev. 07-16-2012
Quick Start Guide INSTEON Thermostat Adapter
This device complies with FCC Rules and Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the device.
Le present appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorise aux deux conditions suivantes: (1) l'appareil ne doit pas
produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible d'en compromettre le fonctionnement.
Controlling Thermostat Adapter
• Tap an On or scene button on a linked controller to recall the thermostat mode and setpoints established during linking
• Tap on Off button on a linked controller to turn off the thermostat mode and setpoints established during linking
• Tap the Brighten ** button on a linked controller to raise the setpoint(s) by a single degree
• Tap the Dim ** button on a linked controller to lower the setpoint(s) by a single degree
**To prevent “runaway” temperature setpoints, these operations only apply to controllers with brighten/dim buttons (e.g.,
RemoteLinc ™ ). For example, pressing and holding the ON/OFF buttons from a SwitchLinc ™ or KeypadLinc ™ will not change the
temperature setpoints.
Programming Thermostat Adapter as an INSTEON Controller
Thermostat Adapter can be used to control remote INSTEON devices when the thermostat switches the A/C, heat or fan on and off.
See your INSTEON device’s Owner’s Manual for more detailed instructions.
The following will work for the most common INSTEON devices:
1) Set your remote INSTEON device to the state you wish to activate from Thermostat Adapter
2) Set your thermostat to the state you wish to use to trigger your remote INSTEON device (Cool, Heat, Fan On mode)
NOTE: Thermostat must be in Off mode to link to Fan On mode
3) Set Thermostat Adapter to linking mode by pressing and holding the Thermostat Adapter Set button for about 5 seconds
Thermostat Adapter LED will begin blinking
Thermostat display will flash all the LCD characters
You will have 4 minutes to complete the next step before linking mode automatically times out
4) Press and hold the Set button on your remote INSTEON device.
Thermostat Adapter LED will stop blinking
Thermostat display will flash all the LCD characters
5) Test that linking was successful by changing the mode on your thermostat to confirm that the remote INSTEON device is working
as expected
Limited Warranty – INSTEON warrants to original consumer of this product for a period of 2 years from date of purchase, this product will be free from
defects in material and workmanship and will perform in substantial conformity with its Owner's Manual. Warranty shall not apply to defects caused by
misuse or neglect.
Protected under U.S. and foreign patents (see www.insteon.com) © Copyright 2012
INSTEON, 16542 Millikan Ave., Irvine, CA 92606, 1-800-SMARTHOME (800-762-7846)
Complete Instructions, Troubleshooting and Tech Support
Owner’s Manual and current Quick Start Guide: www.insteon.com/support
Call: INSTEON Support Line at 800-762-7846