INSTEON Micro Dimmer - 2442-222 (US), 2442-422 (EU), 2442-522 (AUS/NZ) Quick Start User Manual

Quick start guide, Insteon

2442-222, 2442-422, 2442-522 Rev. 6/3/2013 11:07 AM / See Owner’s Manual for Warranty Information.

Protected under U.S. and foreign patents (see www.insteon.com/patents)

Quick Start Guide

INSTEON

Micro Dimmer

Models: 2442-222, 2442-422, 2442-522

Tools Needed

•

Slotted #1 screwdriver

• Voltage meter

•

Philips screwdriver

• Wire cutter/stripper

Installing Micro Module

Installation should only be performed by a qualified electrician or a homeowner

who is familiar and comfortable with electrical circuitry. If you have questions,

consult an electrician or call the INSTEON Support Line at

866-243-8022

1) Write down the INSTEON ID found on the back of the unit (XX.XX.XX)

2) Turn off breaker/fuse and verify that the power is off

3) Disconnect wires from existing switch, fixture or outlet and prep all wires to be

connected to Micro module, with 3/16” (5mm) of bare wire on the ends

4) Connect wires per diagram which corresponds to your installation

Note: sense lines carry very low current (~0.35mA 240V, ~0.17mA for 120V)

5) After ensuring wires are firmly connected and that there is no exposed wire, turn on breaker/fuse

After a few seconds, load will turn on (if wired into switch or fixture) and Micro module LED will turn green

6) Test by tapping Micro module on/off buttons

Load will turn on and off

Micro Module LED will turn green when load is on and red when load is off

7) If installing a single momentary or dual momentary switch

a) Press and hold set button until it beeps

LED will start blinking green

b) Press and hold set button until it beeps a second time

LED will start blinking red

c) Press and hold set button until it beeps a third time

EU/AUS/NZ

North America

Sense #1

(yellow)

Sense #2

(purple)

LED

Antenna

Table of contents