INSTEON KeypadLinc Timer (2484DWH8) Manual - Manual (Page 20)

KeypadLinc Schedule Timer Owner’s Manual
Page 20 of 26
Viewing/Editing a Scene’s On/Off Timers
1) Set KeypadLinc to Programming Mode by pressing & holding the Set button for 3 seconds
The LED will cycle between the On, A, and B buttons
2) Tap the B button to enter Timer Setup Mode
KeypadLinc will beep and the LED will cycle between the On, A, B, C, and D buttons
3) Tap the Scene button you wish to view/edit timers for
KeypadLinc will beep and the LED will cycle between the On and Off buttons
4) Tap either the On or Off button to view/edit the respective timer
KeypadLinc will beep and flash the A, B, C, and D buttons to show the time queried. When
complete, the Scene button will turn on solid and either the On or Off button will begin blinking
If you wish to edit the timer:
a) Tap the A, B, C, and D buttons to enter the desired time
KeypadLinc will beep with each button tap
b) To accept the new timer as an ON time, tap either the On button. Tap the Off button to accept
the new timer as an OFF time.
KeypadLinc will beep and the B button will turn on solid while the On or Off button begins
blinking
5) To view/edit the other timer, tap the button (either On or Off) that is not blinking and repeat step 4.
KeypadLinc will beep and flash the A, B, C, and D buttons to show the timer. When complete, the
Scene button will turn on solid and either the On or Off button will begin blinking
To return to Programming Mode, tap the blinking button (On or Off)
KeypadLinc will beep and the LED will cycle between the On, A, and B buttons
6) Tap the On button to exit Programming Mode and return to normal operation
KeypadLinc will beep and the On or Off button will turn on solid based on the state of the load
Scene button LEDs will turn on solid if the scenes are activated
Disabling a Scene’s On/Off Timers
On/Off timers can only be reset to zero by performing a factory reset (see Resetting KeypadLinc
Schedule Timer to its Factory Default Settings). However, timers can be disabled by setting them with an
invalid time, such as 30:00.
Restoring Power to KeypadLinc Schedule Timer
KeypadLinc stores all of its settings, such as Links to other INSTEON devices, On-Levels/Ramp Rates,
etc., with non-volatile memory. Because settings are saved in this non-volatile memory, they will not be
lost in the event of a power failure.
In the event of a power loss KeypadLinc will automatically return the load to the brightness level it had
before power was interrupted.
NOTE: The KeypadLinc clock will resume once power is restored. When power is interrupted, reset the
time on to ensure timers go on and off as scheduled. See Setting the Clock in KeypadLinc Schedule
Timer.