Owner’s manual and tech support – INSTEON KeypadLinc Dimmer, 8 button (2486DWH8) Quick Start User Manual

Page 2

Limited Warranty – INSTEON warrants to original consumer of this product for a period of 2 years from

date of purchase, this product will be free from defects in material & workmanship & will perform in substantial

conformity with its Owner's Manual. Warranty shall not apply to defects caused by misuse or neglect.

INSTEON, 16542 Millikan Ave., Irvine, CA 92606, 800-762-7845

KeypadLinc will double-beep

and its LED will stop blinking

Responder’s LED will stop blinking and it may double-beep

5) Confirm that scene addition was successful by tapping on/off on the KeypadLinc scene button

The responder will toggle between the scene’s preset on-level and off

6) If you wish to add more responders to the scene, repeat steps 1-5 for each additional scene responder

Add KeypadLinc Button to a Scene as an INSTEON Responder

1) Press and hold the scene controller button until it beeps

Controller’s LED will blink

2) Tap the KeypadLinc button you wish to be a responder of the scene at least once

3) Tap the button again if necessary to get button’s LED to desired state for the scene (press and hold if adding the main scene at a dimmed level)

4) Press and hold KeypadLinc Set button until it double-beeps

KeypadLinc scene button LED will flash once and return to previous state

Controller LED will stop blinking and it will double-beep

5) Confirm that scene addition was successful by toggling the controller scene button on and off

KeypadLinc button LED (and load if main scene) will toggle on and off

Owner’s Manual and Tech Support

Owner’s Manual and current Quick Start Guide:

http://www.insteon.com/support

Call: INSTEON Support Line at 800-762-7845

CAUTION: To reduce the risk of overheating and possible damage to other equipment, do not install to control a receptacle, a motor-operated appliance, a fluorescent lighting fixture or a transformer-

supplied appliance.

Gradateurs commandant une lampe a filament de tungstene – afin de reduire le risqué de surchauffe et la possibilite d’endommagement a d’autres materiels, ne pas installer pour commader une prise,

un appareil a moteur, une lampe fluorescente ou un appareil alimente par un transformateur.

If either the KeypadLinc or responder LED continues to blink, the addition failed. Tap the device’s Set button until LED stops blinking and try again.

If the controller does not have a beeper, wait until its LED begins blinking

Most models