Hach-Lange DR 3800 Additional Software LINK2SC - Manual (Page 23)

11
Operation
2. Return to the laboratory data graph.
3. Press the number at the bottom of the y-axis and change the
lower limit from "1" to "0".
Note: Use the alphanumeric keypad to enter the number and press
OK to confirm.
4. Press the number at the top of the y-axis and change the upper
limit from "2" to "6".
Note: Use the alphanumeric keypad to enter the number and press
OK to confirm.
Laboratory and process data are both displayed in equal ratio in the
resulting diagram.
3.2.5 Additional features
Use the following additional features to change the view of the
displayed graphs and/or to get detailed information of the data:
• Change the design of the graph
• Display results as a 24h Average
• Set control limits