Hach-Lange FILTRAX User Manual - Manual (Page 15)

Installation
13
3.1 Mechanical installation
3.1.1 Dimensions
Fig. 3-8 Control unit
D A N G E R
Select an appropriate installation location for the instrument.
Plan out the mechanical mount before positioning poles or drilling holes. Make sure the
mount has a sufficient bearing capacity. The dowels must be selected and authorized
according to the condition of the wall.
The manufacturer shall accept no liability if the instrument is installed incorrectly.
Plan how to lay cables and tubes and their path in advance.
Lay the tubes, data cables and power cables without any bends and so they do not pose
a tripping risk.
N O T I C E
For information on installation with optional accessories, refer to the relevant installation
instructions.
N O T I C E
The filter module should only be unpacked directly before commissioning and quickly
attached to the module carrier.
The filter membranes are shrink-wrapped in protective plastic; once they have been
moistened they must not be allowed to dry out.