Hach-Lange Sipper Module for DR 5000 - Manual (Page 5)

5
Sipper module
6. Secure the Sipper Module and the Multi Cell Holder with the two locking screws
(
Figure 1 on page 2 ).
7. Contact with instrument has now been established. SIPPER OPTIONS is now available
in Instrument Setup.
8. Pull the pump adjustment forward (item 1, Figure 6 on page 5 ) and open the pump
tubing clamp (item 2, Figure 6 ). Wrap the white pump tubing around the pump and
clamp the ends on the right and left in the two front retainers (item 3, Figure 6 ).The
push-in connectors of the pump tubing must be positioned as in Figure 6 .
9. Clean the Sipper Cell with a lint-free cloth and insert the Sipper Cell (item 1, Figure 7
on page 6 ).
10. Use the outlet connector (item 2, Figure 7 ) to join the white pump tubing
(item 3, Figure 7 ) to the Sipper Cell outlet (item 1, Figure 7 ).
11. Connect the drain tube (item 5, Figure 7 ) to the right end of the white pump tubing.
12. Connect the inlet tube to the inlet of the Sipper Cell (item 4, Figure 7 ).
Figure 6 Pump Adjustment
1 Pump Adjust Forward 2 Pump Tubing Clamp 3 Front Retainers