Hach-Lange Sipper Module for DR 5000 - Manual (Page 3)

3
Sipper module
Sipper module installation
1. Pull the drain tube through the exit channel of the sipper from the inside outwards. Pull
the inlet tube through the entry channel of the sipper module from the outside inwards.
The push-in connectors must be inside the module. Avoid kinks in the tubes.
2. Turn the sipper module on its side. Pull the inlet tube through the entry channel , and
the drain tube through the exit channel of the sipper. The inlet tube must be pulled
through the metal guide tube. The bottom end of the guide tube must click into the
channel. Avoid kinks in the tubes.
3. Hold the rubber fitting with the ridges over the grooves and push it firmly onto the
guide tube and the waste tube.The rubber fitting must firmly enclose the guide tube
and drain tube.
Figure 2 Drain tube and inlet tube installation
Figure 3 Guide tube installation