Hach-Lange SI794 C User Manual - Manual (Page 31)

31
rL . Select limit function /
LiMIT / CtROL / USP
Select contact function Lo / Hi L1 .
Select contact response N/O / N/C
Enter setpoint xxxx
Enter hysteresis xxxx
Enter delay xxxx SEC
Select contact function Lo / Hi L2 .
Enter controller setpoint xxxx
Ct . Enter neutral zone xxxx
(P) Controller gain K
P
xxxx %
(I) Reset time T
R
xxxx SEC
(D) Rate time T
D
xxxx SEC
Pulse length / pulse frequency PLC / PFC
PLC: Pulse length xxxx SEC
PFC: Pulse frequency xxxx /min
Select HOLD response Y Last / Y Off
Select contact response N/O / N/C
Enter setpoint xxxx
Enter hysteresis xxxx
Enter delay xxxx SEC
controller / USP
U1 . Enter reduced USP factor xxxx %
Select contact response N/O / N/C
Enter delay xxxx SEC
Select contact response N/O / N/C
Enter delay xxxx SEC
U2 .
Cln Contact CLEAN / PSet2
Cn . Select as cleaning contact /
Signal for parameter set 2*
rinse / PSet2
Rinsing interval xxx.x h rinse
Rinse duration xxxx SEC
Contact response N/O / N/C
Menu Selection / Default Code
rLAY Relay 1/2: Limits, controller, USP function
*) These parameters are only edited in parameter set 1.
They are valid for both parameter sets.