Summary of led status – normal operation, Summary of led status– fault conditions, Specifications – Clear-Com FreeSpeak Battery Pack Charger User Manual
Page 2: Mains power supply unit, Ac input voltage 100-240vac 50/60hz, Charger, General
CEL-FS-CHRGR Multi-bay Charger Instruction Manual 810366Z – Rev 4.0
©
2006 Vitec
Group
Communications
www.clearcom.com
Clear-Com is a registered trademark of Vitec Group Communications, Inc.
The Clear-Com Logo is a registered trademark of Vitec Group Communications, Inc.
FreeSpeak is a registered trademark of Vitec Group Communications,Ltd
Cellcom is a registered trademark of Vitec Group Communications, Inc.
SUMMARY OF LED STATUS – Normal Operation
Red LED ON………………………………………Fast charging
Green LED ON…………………………………….Trickle charging
SUMMARY OF LED STATUS– Fault Conditions
Charging State
and fault
conditions are
indicated by the
status of the
Red and Green
LEDs of each
charging bay
Red LED Flashing…………………………………Short Circuit in battery pack
Green LED Flashing…………………………..….Cells in pack will not charge
Remove the battery pack and investigate.
OVER-TEMPERATURE
If the temperature of the battery pack exceeds approximately 60°C in fast charge
mode, the charging will revert to trickle charging. The red LED turning OFF, and
the green LED turning ON will indicate this.
Excessive heating of the battery pack may be caused by not using the
recommended batteries or by mixing batteries from more than one manufacturer.
SPECIFICATIONS
Mains Power Supply Unit
AC input voltage
100-240VAC 50/60Hz
Output voltage
+12VDC
Output current (max load)
2.50A
Output
current (min load)
0.00A
Short Circuit Protection
Yes
Charger
Input Voltage
12.0VDC +/- 5%
Max Input Voltage
15.0VDC
Output (5 bays)
Smart charging for 4.8V 2500mAH
battery pack.
Fast Charge Current
800mA
Trickle Charge Current
50mA (average)
Maximum Charge Time
360 minutes
Over-Temperature detect
60 °C
Short Circuit detect
Yes
DC connection Jack
5.5 x 2.1mm (C+)
Batteries
Vitec Group Communications recommend that the charger should only be
used with the following battery types:
PANASONIC P6P 2500mAH / 2600mAH Ni-MH 1.2V AA
General
Operating Temperature
0 °C to 40 °C
Operating Humidity
0% to 90% R.H.
Storage Temperature for
Charger and PSU.
-20 °C to 80 °C
iv.