Final tests, Final tests -4 – Clear-Com PS-702 User Manual

Page 16

P S - 7 0 2 T W O - C H A N N E L P O W E R S U P P L Y

2 - 4

FINAL TESTS

After you turn the power on:
1. Check for proper voltage on pin #2 of any intercom line or jack in a

channel. It should read 26 - 30 volts.

2. Test for proper operation of call signaling. Activate the call signal on any

belt pack or station. The call lights on all other stations on that channel

should illuminate and then go out when the call button is released.

3. Adjust the sidetone null on all stations. (Refer to the manual for each

specific unit for instructions.)