CAME FerniE-S Kit - Manual (Page 3)

INSTALLATION INSTRUCTIONS
CONTENTS
1) Stage 1:- Civil & Mechanical Section Page
1.1 PRE-INSTALLTION CHECK 3
1.2 MOUNTING THE MOTOR BASE PLATE 4
2) Stage 2:- Wiring & Electrical
2.1 FITTING THE CONTROL PANEL IN THE CASING 6
2.2 BASIC CABLE LAYOUT 7
2.3 LOW VOLTAGE CABLE LAYOUT 8
3) Stage 3:- Installation Section
3.1 INSTALLING THE MOTORS 10
3.2 INSTALLING THE DRIVE ARMS 11
3.3 ADJUSTING THE OPEN & CLOSED CAMS 12
4) Stage 4:- Wiring & Electrical (2)
4.1 WIRING THE MOTORS 14
4.2 WIRING THE SAFETY PHOTOCELLS 15
4.3 INSERTING THE FREQUENCY CARD 15
4.4 WIRING IN THE TUNED ANTENNA 16
4.5 CODING THE REMOTE CONTROLS 16
4.6 POWERING UP THE CONTROL PANEL 16
5) Stage 5:- Commissioning the control Panel
5.1 INITIAL WIRING & CONTROL PANEL SETUP 18
5.2 OPENING & CLOSING THE GATES 19
5.3 CONTROL PANEL ADJUSTMENTS 20
5.4 AUTOMATIC CLOSE & SAFETY PHOTOCELLS 21
5.5 PROGRAMMING THE REMOTE CONTROLS TO THE
CONTROL PANEL
22
5.6 FINAL ASSEMBLEY 23
6) Troubleshooting Guide 25
7) Technical Information
7.1 TECHNICAL SPECIFICATIONS 27
7.2 MOTOR TORQUE SETTINGS 28
7.3 ZA5 CONTROL PANEL DESCRIPTION 29
7.4 ZA5 WIRING DIAGRAM 31
7.5 CONTROL PANEL ADJUSTMENTS 32
7.6 ELECTRICAL CONNECTIONS 33
8) Contact Information