CAME Superfrog - Manual (Page 4)

4
T
h
e d
at
a a
n
d i
n
fo
rm
at
io
n r
ep
o
rt
ed
i
n
t
h
is
i
n
st
al
la
ti
o
n
m
an
u
al
a
re s
u
sc
ep
ti
b
le to c
h
an
g
e a
t a
n
y t
im
e a
n
d w
it
h
o
u
t o
b
li
g
at
io
n o
n
C
AM
E c
an
ce
ll
i a
u
to
m
at
ic
i s
.p
.a
. to n
o
ti
fy
u
se
rs
.
ENGLISH
5 Installation
Before proceeding with the installation, it is necessary to:
• Provide for a suitable omnipolar disconnection device with contacts more than 3 mm apart, and independent (sectioned off)
power supply;
• Make sure that any connections inside the case (that provide continuance to the protective circuit) be fitted with extra insula-
tion as compared to the other conductive parts inside;
• Set up a tube to serve as a draining system to prevent water build up and oxidation;
• Make sure that any connections inside the container (made for the continuity of the protection system) are provided with
additional insulation compared to the other conductive parts inside;
• Make sure that the structure of the gate is sufficiently sturdy, that the hinges are in good working order and that there is no
friction among any of the moving parts;
• Make sure there is a mechanical stop for both the opening and closing phases.
The installation must be carried out by export, qualified personnel in total compliance with the norms in effect.
5.1 Preliminary checks
Make sure all tools and materials necessary are within reach to install the edge in total safety, and in compliance with the
regulations in force. The following figure illustrates the minimum equipment needed by the installer.
5.2 Tools and materials