Hydrotech Precision-PWS 8-M_8-MST OWNERS GUIDE User Manual

Page 39

PROBLEM

CAUSE

D) Charcoal Filter is very hot
and steam is escaping from
the filter.

1. The fan switch is turned off. Check Switch.
2. Fan motor is not running properly, may be

defective, or the fan motor switch may be
defective. Call Service Center.

3. Cooling coil fins are plugged with dust, dirt, or

grease. Remove and clean or take to a service
center for maintenance.

4. The location of the water distiller does not

provide enough airflow for good cooling. Move
the water distiller to an area with more air
movement.

E) Water distiller may start
to boil, then shuts off. It
may restart after cooling
down. Very small amount of
water is produced.

1. Faulty Reset button. After letting water distiller

cool down and trying to reset several times, call
Service Center.

F) Water distiller runs
properly but little or no
water is produced.

1. Improper Heating Element is installed or Heating

Element is faulty. Call Service Center.

2. Boiler tank lid is loose. Check by moving Boiler

Tank Lid Knob.

3. Reset button may be defective or weak. See A)

3 above.

G) Strange taste in Distilled
Water.

1. Boiling tank and/or optional storage tank may

require cleaning. See maintenance section on
cleaning water distiller.

2. Boiling tank was over filled.
3. Charcoal filter requires new Coconut Charcoal.

H) Fan does not operate
automatically.

1. Fan switch is in OFF position. Check Switch.
2. Fan motor may be defective. Call Service

Center.

I) Distiller does not seem to
produce as much water as
specified.

See Section in Guide: 10 Factors That Will Affect
Your Water Distiller Production.

Contact any Precision Water Systems Service Center to correct
any problems with your water distiller that are not covered in
this guide.

To locate a Service Center in your area contact the manufacturer at:

Precision Design & Manufacturing Inc.

Westlock,

Alberta,

Canada

T7P

2H7

Email:

Phone: (780) 349 4933

FAX: (780) 349 4957