Hydrotech Precision-PWS 8-M_8-MST OWNERS GUIDE - Manual (Page 21)

Impurities Drain Tube Installation
1. Refer to the Impurities Drain Tube Installation Diagram shown below.
Remove the compression nut and compression sleeve from the Drain
Valve.
DISTILLER HEAD
COMPRESSION SLEEVE
COMPRESSION NUT
MANUAL DRAIN TUBE
DRAIN VALVE
TO SEWER OR
IN A CONTAINER
Impurities Drain Tube Installation Diagram
2. Take the stainless steel manual drain tube from the parts bag. Slip the
compression nut and compression sleeve over the manual drain tube.
3. While holding the compression nut and sleeve on the drain tube, push the
manual drain tube into the drain valve. Push the compression sleeve into
the valve with the nut and thread the nut onto the valve.
4. Position the drain tube away from the distiller and tighten the nut with a
5/8” open end wrench or adjustable wrench. When draining the boiling
tank of the water distiller, the manual drain tube should be drained into a
suitable container or sewer.
21