Hydrotech Precision-PWS 12-12 OWNERS GUIDE - Manual (Page 52)

52
Pantry Faucet Assembly Diagram
2. See Pantry Faucet Assembly Diagram above. Connect the two pieces
of the pantry faucet by first wetting the O rings on the outlet spout (A) with
water or dish soap. Be careful not to damage the O rings when inserting.
Slowly rock the spout as you push it into the tap section (B). Use a cloth
wrapped around the nut first to prevent damage to the nut when
tightening. Turn the nut on the spout with pliers so that it is snug. Do not
over tighten. The O rings will provide the seal for the water. The spout
can be swivelled for convenience after installation is complete.
3. Install the faucet gasket on the faucet threads and insert the pantry faucet
threaded base through the 7/8” hole in the sink. Secure the faucet to the
sink with the faucet nut. Tighten with a basin wrench or pliers.
4. Attach ½” OD water tube to the pump outlet elbow with a ½”
Nut/Cone/Ring. Tighten with a 10” adjustable wrench or basin wrench.
CONNECTION NUT
BEFORE AFTER
O-RING
TAP (B)
OUTLET SPOUT (A)