Hydrotech Precision-PWS 12-12 OWNERS GUIDE - Manual (Page 50)

50
PWS APK-1 Hose Installation Diagram
13. Slide a Nut/Cone/Ring over each end of the1/2” OD tube and insert the
hose into each elbow. Slide the nut to the threads and tighten using a 10”
adjustable wrench. Use caution. Do not over tighten.
14. Screw the third elbow to the outlet of the pump. Tighten with a 10”
Adjustable wrench in a position that will work for routing the hose to the
faucet (usually toward the ceiling or floor). Be careful not to over tighten
as you could damage the pump.
OUTLET
INLET
DRAIN
PUMP ASSEMBLY
1/2FPTX1/2
ELBOW ELBOW
1/2FPTX1/2
CONE
RING
NUT 1/2"OD TUBE
RING
NUT CONE
1/2"OD TUBE MEASURE LENGTH
ADD 1-1/2" TO THE MEASURED LENGTH
MEASURED LENGTH
1-1/2" ADDED TO THE MEASURED LENGTH